TURBO-BOOST-TEST TURBOCHARGER TESTING BENCH
The bench is used to check the supercharger characteristics after a repair of a turbocharger with or without vacuum or electronic control. On the bench it is possible to adjust the geometry of the turbine in dynamic mode, when the shaft is rotating. The N75 valve check function helps find faults in the control of the turbocharger on the vehicle. Engine repair shops can use this bench for a comprehensive evaluation of the turbocharger’s performance before installing it on an engine. The test bench can be used in turbine tuning and revamping, in the manufacture of hybrid turbines, to check changes in turbine performance after tuning.
WE PROVIDE A COMPLETE SOLUTION, SUPPORT AND TRAINING WHEN YOU PURCHASE
Our company has a technical support service center. If you have any questions, you can contact us for help.
|Parameters||TURBO BOOST TEST|
|The largest mass of a balanced turbocharger, kg||9|
|The maximum diameter of the compressor wheel, mm||80|
|Maximum achievable rotor speed, rpm||50 000|
|Required pressure to the pneumatic system, MPa||0,8 – 1,0|
|Maximum productivity of the vacuum pump, m3||180|
|Overall dimensions of the machine (length x width x height), mm||780 х 1120 х 1274|
|Machine weight, kg (approximately)||285|
|Power supply parameters||380V ± 10%, 3 Ph, 50Hz ± 1|
|Power consumption, not less than kW||1,5|
|Balancing system of the machine||BOOST TEST|
|Foundation requirements||The machine is installed on a concrete hard floor in a workshop.|
PURCHASE SUPPORT AND TRAINING
Our company has the service center for technical support.
In case of any questions you can contact us for help.
LEARN MORE ABOUT OTHER MACHINES IN THE SERIES
The page lists the characteristics of the basic model of the machine. Almost any parameter(diameter, length, weight, etc.) of the machine can be changed on the customer’s request. When ordering the machine, all parameters of the machine will be agreed additionally.