TURBO-BOOST-TEST TURBOCHARGER TESTING BENCH

The bench is used to check the supercharger characteristics after a repair of a turbocharger with or without vacuum or electronic control. On the bench it is possible to adjust the geometry of the turbine in dynamic mode, when the shaft is rotating. The N75 valve check function helps find faults in the control of the turbocharger on the vehicle. Engine repair shops can use this bench for a comprehensive evaluation of the turbocharger’s performance before installing it on an engine. The test bench can be used in turbine tuning and revamping, in the manufacture of hybrid turbines, to check changes in turbine performance after tuning.

WE PROVIDE A COMPLETE SOLUTION, SUPPORT AND TRAINING WHEN YOU PURCHASE

Our company has a technical support service center. If you have any questions, you can contact us for help.

SPECIFICATIONS

Parameters	TURBO BOOST TEST
Maximum air flow rate of vortex compressor, m³/min	110
Maximum pressure of vortex compressor, mbar	900
Maximum vacuum created by the vacuum pump, mbar	-800
Maximum rotor speed, rpm	50 000
Nominal operating pressure of the lubricating system, MPa	0,5
Overall machine dimensions (length x width x height), mm	1330 х 770 х 1440
Weight, kg (approximately)	250
Parameters mains supply	380V ± 10%, 3 Ph, 50Hz ± 1
Minimum Power input, kWt	6
Requirements for foundation	_ Machine mounted on an ordinary hard floor in the workshop
Operating conditions of the machine	+5° … +40°C

SUPPORT AND TRAINING ARE FREE

Our company has the service center for technical support.
In case of any questions you can contact us for help.

Balancing assistance

We are ready to support you in any balancing issues your workpieces

Personnel training

We train personnel in the operation and maintenance of the machines.

Warranty & Service

Our service engineers are ready to provide you with professional assistance

LEARN MORE ABOUT OTHER MACHINES IN THE SERIES

HIGH-SPEED VSR TURBO BALANCING MACHINE SBR-10

High-speed balancing of turbochargers at speeds reaching maximum operational values to eliminate the dynamic deflection of the turbine rotor

Flow test bench for turbochargers GEOMET-2000

Static calibration and testing of VNT turbochargers with vacuum, air and electronic control.

ELECTRONIC ACTUATOR TESTER ATP-1000

Diagnostics of actuators (electric valves, DC motors ) and VNT turbochargers also boost control solenoids.

BALANCING MACHINE FOR TURBOCHARGER CHRA DBST-10

Low-speed balancing of the rotor in the turbocharger center housing rotating assembly, and is also used to check oil leakage the turbocharger after the assembly operation

The page lists the characteristics of the basic model of the machine. Almost any parameter(diameter, length, weight, etc.) of the machine can be changed on the customer’s request. When ordering the machine, all parameters of the machine will be agreed additionally.