BALANCING MACHINE FOR 4-SUPPORT DRIVESHAFTS BVI-03-77D
The method of eliminating the imbalance is by welding corrective weights (plates) by contact welding. The machine is equipped with one welding tongs on guides, with the ability to move along the bed
Design features
the possibility of balancing 2, 3 and 4 support cardan shafts; frequency-controlled asynchronous electric drive; combination of optimal design and low cost; displaying the magnitude and angle of imbalance on a 17-inch touch screen monitor in 4 planes simultaneously; simple and intuitive software interface.
BALANCING SYSTEM AND CONTROL
We make balancing easier – the main advantage characterizing our balancing systems.
- Ease of use and simple operation do not require special theoretical knowledge from the operator.
- Displays the balancing process in real time and monitors the unbalance behavior of the rotor on the screen to achieve the best possible result.
- The maximum sensitivity of the machine at any moment of operation, set-up and calibration of the machine is carried out by the operator himself.
- Free from the influence of external vibration factors on the measuring result, has a high degree of protection against various types of disturbance.
- World-leading functionality and accuracy due to 40 years of industry development and application experience.
| Options | BVI-03-77D |
|---|---|
| Machine type | pre-resonant |
| Mass range of balanced rotors, kg | 5 … 150 |
| Maximum pipe diameter, mm | 140 |
| Maximum flange diameter, mm | 250** |
| Maximum length of cardan shaft, mm | 200 … 4200* |
| Number of supports | 4 |
| Number of simultaneously measured planes | 2, 3, 4 |
| Rotor speed range, rpm | 400 … 4000 |
| Minimum achievable residual imbalance, g mm / kg | 5 |
| Machine weight, without base cabinet, kg | no more than 1900 |
| Balancing protocols: printed out on a laser printer connected to the PAK-4 via the USB port, recorded on a USB flash drive or transferred via an Ethernet channel | + |
| Transmission type | Belt |
| Machine balancing system | PAK-4 |
| Calibration of the balancing system of the machine | Calibration weights, 3-run method |
WE PROVIDE A COMPLETE SOLUTION, SUPPORT AND TRAINING WHEN YOU PURCHASE
Our company has a technical support service center. If you have any questions, you can contact us for help.
FOR FREE
We will calculate the tolerances for the permissible residual disbalance according to your drawings. Balance correctly!
